Installation Of The Chlorine Generator Device; User Interface On An Aqualink ® Rs Or; Pda Bezel; Figure 9. Installation Of The User Interface - Nature2 Fusion soft Serie Manual De Instalación Y Operación

Page 18
3.10 Installation of the Chlorine Generator Device User Interface on an AquaLink

PDA Bezel

1. On the chlorine generator user interface board, connect one end of the ribbon cable to the 16-pin J1 connector as
shown in Figure 9.
2. Connect the other end of the ribbon cable to the power interface 16-pin J1 connector.
3. Attach the chlorine generator user interface board to the bezel using the four (4) screws provided.
J1 Connector,
Power Interface
Board
Ribbon Cable
Figure 9. Installation of the User Interface
Nature Fusion Soft Installation and Operation Manual
2®
J1 Connector,
User Interface
RS or
®
2 1
4 3
Screws (4)