Using A Power Cord To Charge The Battery - Invacare Stand Assist Manual Del Usuario

Invacare® Stand Assist

4.7.2 Using a Power Cord to Charge the Battery

This procedure only applies to the RPS350–1FR.
A = Power Cord Connects Here
22
CAUTION!
– The emergency stop MUST NOT be activated -
otherwise it will be impossible to charge the battery.
While charging takes place, the patient lift cannot
be used. DO NOT attempt to move the patient lift
without unplugging the power cord from the wall
outlet. DO NOT attempt to use the patient lift if
the battery housing is damaged. Replace a damaged
battery housing before any further use.
1. Attach the power cord to the control box.
2. Plug the power cord into a power outlet.
The battery will charge in approximately 4 hours.
Charging must be done in a room with good air
ventilation.
3. Disconnect the power cord from the power outlet after the
battery has been fully charged.
1078985-G