Legal Information; Technical Data; Description Du Produit - Ottobock 6A20-30 Instrucciones De Uso

► Always verify that the pin is engaged in the lock before using the
prosthesis.
The liner and shuttle lock are connected to each other with the pin.
The pin engages in the shuttle lock and holds the liner in place.
Putting on the Liner
1) Check the pin and liner for damage.
2) NOTICE! Align the pin with the longitudinal axis of the resid­
ual limb to prevent damage.
Roll up the liner and place it on the end of the residual limb.
3) Unroll the liner onto the residual limb so that it has no wrinkles,
without shifting the soft tissue.
4) Check the fit and the alignment of the liner.
Donning the Prosthetic Socket
1) Slide into the prosthetic socket with the liner until the pin slides
into the opening of the shuttle lock.
2) Insert the pin fully into the shuttle lock.
3) Before using the prosthesis, verify that the pin is fully engaged in
the shuttle lock.
Doffing the Prosthetic Socket
► Press and hold the side button and pull the residual limb with the
liner out of the prosthetic socket.
7 Maintenance
► A visual inspection and functional test of the prosthetic compon­
ents should be performed after the first 30 days of use.
► Inspect the entire prosthesis for wear during normal consulta­
tions.
► Conduct annual safety inspections.

8 Legal information

All legal conditions are subject to the respective national laws of the
country of use and may vary accordingly.
8.1 Liability
The manufacturer will only assume liability if the product is used in
accordance with the descriptions and instructions provided in this
document. The manufacturer will not assume liability for damage
caused by disregarding the information in this document, particularly
due to improper use or unauthorised modification of the product.
8.2 CE conformity
This product meets the requirements of the European Directive 93/42/
EEC for medical devices. This product has been classified as a class I
device according to the classification criteria outlined in Annex IX of
the directive. The declaration of conformity was therefore created by
the manufacturer with sole responsibility according to Annex VII of the
directive.

9 Technical data

Reference number
Weight [g]
System height [mm]
Material (lamination anchor)
Material (shuttle lock)
Max. body weight [kg]

1 Description du produit

INFORMATION
Date de la dernière mise à jour : 2018-04-17
► Veuillez lire attentivement l'intégralité de ce document avant
d'utiliser le produit.
► Respectez les consignes de sécurité afin d'éviter toute blessure
et endommagement du produit.
► Apprenez à l'utilisateur à bien utiliser son produit et informez-le
des consignes de sécurité.
6A20=30
315
25
Steel
Aluminium
125
Français
13