Lifan 160F Manual Para El Usuario página 33

a) Turn off the oil fi ller cap and drain plug to
drain engine oil thoroughly. Reinstall the drain
plug and screw in securely (Fig. 22).
b) Fill the specifi ed engine oil to the upper lever
mark.
c) Reinstall the oil fi ller cap. Engine oil capacity
of the 1/2 re duction gear box is 0.5 liters; engine
oil capacity of the crankcase is 0. 6 liters.
NOTE
Do not dump oil containers or discarded
engine oil into rubbish boxes or onto the
groud. For the sake of environmental
protection, we suggest you take in dis carded
engine oil with a closed container and bring to
local recycling station.
2. SERVICE OF AIR CLEANER
A dirty air cleaner may block enough air's fl owing into
the carburetor. To keep the carburetor in good working
conditions, please service the air cleaner peri odically. If
operating the engine in extremely dusty area, the job
should the done more often.
WARNING
Never clean the air cleaner core in gasoline
or low fl ash-point detergents, or explosion
may happen.
CAUTION
Never run the engine without an air cleaner, or
air with dirt and dust may enter the engine so
speed the engine's wear.
Double-core type (Fig. 23)
Unscrew the wing nut, dismantle the air cleaner housing.
Check the two cores for dam age. If any, replace with new
one.
a) Foam fi lter element: clean with home detergents and
warm water (or non-fl ammable of high fl ash-point
cleaning solvents ) and dryup, then soak in clean engine
oil until saturated. Squeeze out excess oil, otherwise, the
engine will discharge smoke in starting stage.
b) Paper fi lter element: knock the core against a solid
plane to get rid of accumulated dust or blow out dust
from inside to outside with high-pressure air fl ow (not
more than30 psi). Never clean with a brush, as burshing
may force the dust into the core fi ber. If the core is
extremely fi lthy, replace it with a new one.
Dust-collecting type (Fig. 24)
Unscrew the wing nut, dismantle the air cleaner housing,
check the two cores for dam age. If any, replace damaged
core with new one.
a) Foam fi lter element: clean with home detergents
and warm water (or non-fl ammable or high fl ash-point
cleansing solvents) and dry up, then soak in clean engine
oil until sat urated. Squeeze out excess oil, otherwise, the
engine will discharge smoke in starting stage.
Dipstick
Drain plug
Dipstick
fi g. 22
Air cleaner housing
Paper fi lter element
Foam fi lter element
fi g. 23
Pre-air cleaner cover
Groove
Air guide
Projection
of air inlet
Dust-collecting
cup
EN
Drain
plug
Wing nut
Wing nut
Paper fi lter
element
Foam fi lter
element
fi g. 24
33