Cleaning And Maintenance; Cleaning And Maintenance By The User; Routine Maintenance - Extraflame HP 15 Manual Del Usuario

CLEANING AND MAINTENANCE

For proper operation, the generator must undergo routine maintenance carried out by a quali ed technician, at least once a
year. Inspection and maintenance activities must be performed by specialized technicians who are familiar with the instructions
in this manual.
ALWAYS FOLLOW THE INSTRUCTIONS IN MAXIMUM SAFETY CONDITIONS!
Š Make sue the power cable is unplugged since the generator could be programmed to start.
Š That the generator is cold in its entirety.
Š The ashes are completely cold.
Š Ensure an e ective exchange of air in the room during the cleaning of the product.
Š A poor cleaning is detrimental to the proper functioning and safety!
IF THE POWER SUPPLY CABLE IS DAMAGED, IT MUST BE REPLACED BY THE AFTER SALES SERVICE OR BY
A SIMILARLY QUALIFIED PERSON, SO AS TO AVOID ALL RISKS.
EVERY YEAR MAKE THE EXHAUST FUMES, SMOKE DUCTS AND "T" FITTINGS, INCLUDING CAPS AND
INSPECTION DOORS BE CLEANED IF ANY CURVES AND ANY HORIZONTAL SECTIONS!
THE CLEANING OF THE GENERATOR FREQUENCY IS APPROXIMATE! THEY DEPEND ON THE QUALITY OF
THE PELLETS USED AND THE FREQUENCY OF USE.
IT CAN HAPPEN THAT THESE OPERATIONS SHOULD BE PERFORMED MORE FREQUENTLY.

CLEANING AND MAINTENANCE BY THE USER

The cleaning process should be borne by the user of the generator and must be done by paying maximum attention after
reading the information on the procedures described in this manual.
MAINTENANCE OF SURFACES AND COATING
The surface cleaning must take place when both the generator and the coating are completely cold. For the maintenance of
surfaces and metal parts, simply use a damp cloth with water or mild soap and water.
Never use abrasive cleaning agents or aggressive solvents for cleaning! Failure to observe the instructions may damage the
surface of the generator.
CLEANING THE CERAMIC GLASS
The cleaning of the ceramic glass is allowed only when the latter is completely cold. Clean the ceramic glass surface using a dry
brush or in the case of a very dirty surface a speci c detergent by sprinkling a small amount on a cloth and then passing it on
the ceramic glass.
Do not spray cleaner or any other liquid directly on the glass or on the gaskets.
CLEANING THE TANK PELLETS
When the tank empties completely, unplug the power cord from the generator and remove residues (dust, chips, etc..) from the
tank empty, before lling it.

ROUTINE MAINTENANCE

In order to guarantee proper functioning and safety of the device, the operations indicated below must be performed every
season or more often when necessary.
DOOR, ASH DRAWER AND BRAZIER GASKETS
The gaskets ensure the tightness of the generator and its resulting good operation.
It is necessary that they are checked periodically and if worn or damaged they must be replaced immediately.
These operations must be carried out by a quali ed technician.
ENGLISH 75