Checking/Replacing Battery Of Beeper Collar; Advice - Num'axes CANIBEEP RADIO PRO Manual De Instrucciones

- Retighten the screw.
- Check the remote control operates correctly.

Checking/replacing battery of beeper collar

The battery condition is checked in 3 distinct occasions:
- when you insert the battery
- when you turn the collar On
- when you turn the collar Off
During these 3 operations, if there are 6 close low pitch beep sounds (instead of 1 or 2 low pitch
beep sounds) and if the LED fl ashes rapidly, your battery is weak.
Replace the old battery with a new one of the same type (see § Fitting the battery in the
CANIBEEP RADIO PRO collar).
NUM'AXES advises to use the same type and same brand of batteries as those supplied in
your new purchased product.
Other brands of batteries may not operate, or may not be completely compatible with your
product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
When changing the battery, there can remain some power in your CANIBEEP RADIO PRO collar.
In that case, the collar does not emit any low pitch sound and the LED does not light when
inserting the new battery.
To make sure it operates properly and that the battery is well inserted, turn on your collar with
your remote control (see § Switching on the collar).

Advice

If your dog has never been used to wearing a beeper collar, we recommend you to use CANIBEEP
RADIO PRO in trace mode for the 2 or 3 fi rst times: with time your dog will familiarize himself
with the beeper.
When you put CANIBEEP RADIO PRO collar around your dog's neck, direct the sound diffuser
towards the dog's body, so that the beep noises do not come too close to your dog's ears.
We advise you to program your CANIBEEP RADIO PRO collar before putting it on your dog's neck:
– modes 1 to 4 : operates only when the dog is pointing.
– modes 5 to 8 : operates when the dog is moving and then pointing.
- modes 9 to 12 : emits a beep sound when you press the button of the same colour as the
one of the collar.
GB - 34