Principle Of Operation; Safety Information - EdilKamin LOGO Instalación Uso Y Mantenimiento

PRINCIPLE OF OPERATION

he LOGO stove produces hot air using wood pellets as fuel,
with electronicall controlled combustion. ereunder is the
e planation of its functions (the letters refer to gure ).
he fuel (pellets) is provided b the storage hopper ( ) and,
to the combustion chamber ( ) b means of a feed screw ( ),
which is driven b a gear motor ( ).
he pellets are ignited b the air that is heated b an electrical
resistance (E) and drawn into the combustion chamber
b a smoke e tractor (F).
he fumes produced during the combustion process are e -
tracted from the hearth b the same centrifugal fan (F) and
e pelled through the outlet (G) located on the lower part at the
back of the stove.
he hearth is covered in cast iron, and closed frontall b a
glass ceramic door (to open use the dedicated "cold hand"
handle").
Fuel quantit , smoke e traction and combustion air suppl
are all controlled b an electronic control board, which is
equipped with Leonardo ® software to achieve high combustion
ef cienc and low emissions.
he s noptic panel ( ) is installed on the top, through which
all phases of operation can be displa ed and controlled.
he main phases can be controlled via the optionall supplied
remote control.
he main functions can also be controlled b remote control.
serial port is found at the back of the stove (optional cable
code ) to be connected to devices that allow remote
ignition (e.g. remote telephone, local thermostat).
D
F
g.

SAFETY INFORMATION

he LOGO stove is designed to heat, through automatic pellet
combustion in the hearth, the room where it is installed, both
b radiation and the air that comes out of the front grille.
to non-compliance with installation instructions, direct contact
with live electrical parts (internal), contact with the re or hot
parts (glass, pipes, hot air output), or foreign substances being
put in the stove.
Onl use wood pellets as fuel.
Should components fail, the stoves are equipped with safet
devices that guarantee automatic shutdown. hese are activated
without an intervention required.
accordance with the instructions given herein and the door
must not be opened during operation combustion is full
automatic and requires no intervention.
entered into the hearth or hopper.
(the ue section connecting the stove smoke outlet to the
chimne
OL .
(e.g. GlassKamin Edilkamin) and a cloth.
b Edilkamin-quali ed
M
ce centre) in accordance with the instructions provided here
within; this is an essential requirement for the validation of the
guarantee.
When the stove is in operation, the e haust pipes and door
become ver hot (do not touch without wearing the thermal
glove).
A
stove.
embers.
B
the stove is installed, nor the air inlets of the stove itself.
E
with wet hands.
C
G
re prevention and equipped with all that is required (power
and air suppl and outlets) for the stove to function correctl
and safel .
COMBUSTION CHAMBER MUST NOT BE DEPOSI-
- 21
-
he onl risks that ma derive from using the stove pertain
n order to function correctl , the stove must be installed in
nder no circumstances should an foreign substances be
o not use ammable products to clean the smoke channel
ue).
he hearth and hopper parts must onl be cleaned when
he glass can be cleaned when OL with a suitable product
o not clean when hot.
ake sure the stove is installed and ignited the rst time
personnel (technical assistan-
o not place an thing, which is not heat resistant near the
E ER use liquid fuel to ignite the stove or rekindle the
o not obstruct the ventilation apertures in the room where
o not wet the stove and do not go near electrical parts
o not use reducers on the smoke e haust pipes.
he stove must be installed in a room that is suitable for