SPE SEGUNDA SERIE Manual De Usuario página 69

In the following picture can be seen, as an example, the Power Control (15%) setting
relative to the same band (20 m), but using the HALF mode selection instead.
Once adjusted the proper preset, go to TX mode (RTTY, CW) to verify the output power
ATTENTION! It is strongly recommended to start with a low preset value (e.g. 10) and
progressively increasing it; this is to avoid the linear overdriving.
The output power levels to reach are about 900 W (FULL mode) e 500 W (HALF mode).
The following empty table could be useful as a template for the FlexRadio user's Power
Control presettings.
Band 160 m 80 m
HALF
FULL
Manual de usuario
40 m 30 m 20 m
Página 69 de 69
17 m 15 m 12 m
EXPERT 1K-FA
10 m 6 m