Fox F36-527C Manual De Instrucciones página 64

4. After carrying out the previous phases, the parts are as the ones of Fig. 9 below.
.
5. Then fix the horizontal clamp on machine's workbench. The arrows indicate the positions in which you
have to fix the metal part and log plastic piece on the workbench by using 2 M5 bolts.
Lastly, use two 2 M5 10 mm hexagonal headed bolt and two 10 mm nuts in order to fix the part illustrated
in fig. 3 to the main part thanks to the two holes marked with no. 1 (Fig.1). The main part of the assembly
is finished. You can check that all parts are correctly assembled in order to grant a suitable safety level
while you are using the machine.
You must assemble the miller under the workbench by using the plate (see previous par. "Use of the miller").
Given the peculiarity of the miller support, every miller needs a different drilling of the fixing plate.
It is essential that the miller is perfectly fixed to the workbench with the suitable screws and bolts.
In case of doubt, contact your retailer or the after-sales service.
EN
Figure 9
64