Malfunctions; After Sales Service - Fox F36-527C Manual De Instrucciones

PROBLEM
The saw does not start:
Machine vibrations:
Wood darkens while cutting:
The tools wear rapidly:
The engine does not work properly:
Blade stops rotating:
The blade rejects the wood:
Other:
All the tools and accessories are made and tested by using the safest and most modern productive methods.
However, if a tool get damaged, it must be repaired by an authorized after sales centre.
You can call the phone number 051/6946469 or by sending a request to the e-mail address
info@fox-machines.com
EN

MALFUNCTIONS

POSSIBLE CAUSE
The electric current is missing in the socket to which the supply
cable is connected.
The supply cable is faulty
The engine is damaged or the carbon brushes must be replaced
The inclination lock handle is not correctly tightened
The blade is not correctly fixed
The tool is not correctly sharpened
The tool has been assembled back-to-front
The tool is not correctly sharpened
The wood is dirty (cement, sand, etc.)
(excessive heating, exaggerate twinkle of the carbon brushes
and consequent noise accentuation)
The engine may be damaged: get the machine checked by an
electrician
Carbon brushes must be replaced
Surcharge (the speed is too high, the tool is not sharpened)
The rip fence is not parallel
The riving knife is not aligned correctly
The bearings make noise: get them changed
Check that the play of the gears and if necessary get them
changes by an after-sales center

AFTER SALES SERVICE

66