Wall Mounting; Installation - SATA clean RCS Serie Instrucciones De Servicio

clean RCS micro.
■ Compressed air pipe with min. 9 mm inner diameter.
■ The installation site must be protected from mechanical impacts.
8.1. Wall-mounting
The SATA clean RCS are mounted firmly to a wall in vertical position us-
ing the supplied fastening kit, with two 8 mm screws.
■ Drill fastening holes according to hole pattern [4] / [5] / [6].
■ Put the fastening screws with flat washer through the predrilled fasten-
ing holes in SATA clean RCS [4-1] / [5-1] / [6-1] and screw into the wall.
8.2. Connect the earthing connection
Notice!
Always comply with the national explosion protection regulations and
occupational health and safety regulations when fitting an earthing con-
nection.
If cleaning agents containing solvents are going to be used, SATA clean RCS
must always be earthed by a qualified professional. When fitting an earthing
cable, use the drilled hole provided [1-7] / [2-6] / [3-10].

9. Installation

Only use priming tanks [1-9] / [2-9] and collecting tank [1-10] / [2-10] that
are capable of conducting or discharging electricity.
Attention!
Health risk from toxic vapours
Toxic vapours can be emitted by the cleaning agents when operating
SATA clean RCS.
→ Install SATA clean RCS in well aired and ventilated surroundings.
→ Where possible, connect SATA clean RCS to an exhaust air system.
Notice!
The pressure must be released from the compressed air pipe before
connecting to the units.
For SATA clean RCS the turbo cleaner
Operating Instructions SATA RCS
Warning! Risk of explosion!
EN
107