Setup; Menu Structure Of Setup; Sample Id; User Id - Mettler Toledo SevenGo Duo Pro Instrucciones De Manejo

5 S etup
5.1 M enu structure of setup
The individual items of the menu setup are described on the pages following the list below.
1. Sample ID
1. Enter Sample ID
2. Select Sample ID
3. Delete Sample ID
2. User ID
1. Enter User ID
2. Select User ID
3. Delete User ID
3. Data Logging
1. Automatic Storage
2. Manual Storage
3. Timed Interval Readings
5.2 S ample ID
An alphanumeric sample ID with up to 12 characters can be entered. Alternatively, a previously
entered sample ID can be selected from the list. If a sample ID has been entered, which is either
pure l y numeric (for example, 123) or ends with a number (for example, WATER123), the fol l ow-
ing options are available:
1. <Auto Sequential> On
Using this setting will automatically increment the sample ID by 1 for each reading.
2. <Auto Sequential> Off
The sample ID is not incremented automatically.
A maximum of 5 sample IDs are stored in memory and listed for selection. If the maximum of 5
has already been entered, a sample ID can either be deleted manually or the oldest ID will be auto-
mat i c al l y overwritten by the new ID.
5.3 U ser ID
A user ID with up to 8 characters can be entered. Alternatively, a previously entered user ID can be
select e d from the list.
A maximum of 5 user IDs are stored in memory and listed for selection. If the maximum of 5 has
already been entered, a user ID can either be deleted manually or the oldest ID will be auto m at i c al-
ly overwritten by the new ID.
5.4 D ata logging
The meter stores up to 500 sets of measurement data in the memory. The number of data sets al-
ready stored in the memory is indicated by MXXX on the display. A message appears on the dis-
play when the memory is full. To save further measurements if the memory is full, data has to be
delet e d first. When measuring in dual channel mode (only SG98), both results will be stored sep a -
rate l y. Therefore, the memory number in this case will increase by 2. You can select between auto-
mat i c and manual storage or you can log your data into the memory in a user-defined interval:

24 Setup

51710917_V02.2011_BA_SG9_98_EnFrEs.indb 22
4. Data Transfer Settings
1. Interface
2. Printout Format
5. System settings
1. Language
2. Time and Date
3. Access Control
4. Acoustic Signal
5. Routine/Expert Mode
6. Screen Settings
1. Screen Contrast
2. Auto-Shutoff
3. Backlight Off
6. Instrument Self-test
21.04.2011 11:46:02