Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

the screen and may be accompanied by an acoustic signal. The message "outside limits" also ap-
pears on the GLP printout.
6.10  S ensor ID/SN
1. Enter Sensor ID/SN
An alphanumeric sensor ID with up to 12 characters can be entered. The sensor ID will be as-
signed to each calibration and measurement value. This is valuable for tracing back data.
Up to 5 sensor IDs can be entered for each sensor type.
If a new sensor ID is entered, the theoretical calibration slope and offset for this type of electrode
will be loaded. The sensor has to be newly calibrated.
If a sensor ID is entered, which is already in the memory of the meter and has been calibrated be-
fore, the specific calibration data for this sensor ID will be loaded.
When a new ion sensor ID is entered, the electrode type can be selected.
When connecting an ISM
Automatically recognize the sensor when it's turned on (alternatively, when pressing READ or
CAL)
Load the stored sensor ID, sensor SN and sensor type as well as the latest calibration data of
this sensor
Use this calibration for the subsequent measurements
The sensor ID for analog ISM
ISM
sensors.
®
2. Select Sensor ID
Already entered sensor IDs can be selected from a list.
If a sensor ID is selected, which is already in the memory of the meter and has been calibrated be-
fore, the specific calibration data for this sensor ID will be loaded.
You can delete a sensor ID with its calibrations in the calibration data menu.
34 Menus and settings
51710917_V02.2011_BA_SG9_98_EnFrEs.indb 32
sensor to the meter, the meter will:
®
sensors can be changed, However, this is not possible for digital
®
21.04.2011 11:46:16

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sevengo proSevengo optioxSg9Sg98

Tabla de contenido