3C. Instellingen - Tacx NEOBIKE Manual De Usuario

3. Quick start guide
Front gears
Current setting of the front gears. You can switch the front gears by pressing the left shifters. Gear up
with the big shifter (C8) or down with the small shifter (C9).
Cassette
Current setting of the cassette (rear gears). You can adjust the rear gears by pressing the right shifters.
Gear up with the big shifter (C8) or down with the small shifter (C9).
Training mode
When you're cycling in stand alone mode (without any software), this field shows the mode you're
training with. You can set the required mode as described in 3c. There are three modes:
1. Simulation mode
Train based on a fixed incline; this can be set by pressing the control buttons (C6).
The virtual shifters (C8 and C9) are enabled.
2. Power(erg) mode
Train based on a fixed power value; this can be set with the control buttons (C6).
3. Resistance mode
Train with predefined resistance levels (10). Switching between levels can be done with the control
buttons (C6).
3c. Settings
You can change the settings (metrics, average power settings and training mode) of the NEO Bike by
the control buttons (C6) and the shifters (C8 and C9).
Do so as follows:
1. Press the control buttons (C6) for 3 seconds. The modes on the display will blink.
2. Press the small shifter (C9) on the right side to select which term you wish to change.
3. Press the big shifter (C8) on the right side to change the selected term.
4. Confirm the setting by pressing the small shifter (C9) on the right.
5. Start training.
6. Change the set incline/power/resistance position by the handlebar buttons.
- 18 -