Fujitsu Control 4 Serie Guia Del Usuario página 31

3. Local and Remote Configuration
4. In the Login Timeout field, enter the amount of inactive time you want to pass
before you must log in again (from 21 to 120 seconds).
5. Select or deselect the Enable Preemption Timeout check box.
6. In the Preemption Timeout field, enter the amount of time (from 1 to 120
seconds) that a prompt will be displayed to inform you that your session is
going to be preempted.
7. Click Save.
To configure KVM session settings:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Sessions > KVM. The Appliance KVM Session Settings screen
appears.
2. Select an encryption level for keyboard and mouse signals (128-bit SSL,
DES, 3DES, or AES) and for video signals (128-bit SSL, DES, 3DES, AES, or
None).
3. Select a language from the Keyboard drop-down menu.
4. Click Save.
To configure serial session settings:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Settings > Serial. The Appliance Serial Session Settings screen
appears.
2. Either enable or disable the Telnet Access Enabled check box.
3. Click Save.
Closing a session
To close a session:
1. From the side navigation bar, select Active Sessions to display the Appliance
Sessions screen.
2. Click the check box next to the desired target device(s).
3. Click Disconnect.
If there is an associated locked virtual media session, it will be disconnected.
To close a session (local users only):
1. From the side navigation bar, select Local Session.
26
590-1058-640A