Appendix B: Using Kvms4 Adapter Serial Cables - Fujitsu Control 4 Serie Guia Del Usuario

Appendix B: Using KVMs4 Adapter Serial cables

Using KVMs4 Adapter Serial Cables
An administrator can choose between the ACS console server and
Cisco pinouts for each serial adapter cable port via the local user
interface or the remote OBWI. ACS is the default.
To change the pinout to Cisco mode:
1. Select Unit View - Appliance - Appliance Settings - Ports >
Adapter Cable.
2. Click on the desired serial adapter cable(s).
3. Select Settings > Pinout.
NOTE: If the DB-9 adapter is used, select the ACS console server pinouts.
ACS console server port pinouts
The following table lists the ACS console server serial port pinouts for
the serial adapter cable.
Table B.1: ACS Console Server Serial Port Pinouts
Pin No.
1
2
3
4
5
6
7
8
590-1058-640A
Appendix B: Using KVMs4 Adapter Serial cables
Signal Name
RTS - Request to Send
DTR - Data Terminal
Ready
TXD - Transmit Data
GND - Signal Ground
CTS - Clear to Send
RXD - Receive Data
DCD/DSR - Data Set
Ready
N/C - Not Connected
Input/Output
OUT
OUT
OUT
N/A
IN
IN
IN
N/A
77