Setting Event Destinations; Configuring Adapter Cables - Fujitsu Control 4 Serie Guia Del Usuario

3. Local and Remote Configuration
2. Specify the events that will generate notifications by clicking the appropriate
check boxes in the list.
-or-
Select or clear the check box next to Event Name to select or deselect
the entire list.
3. Click Save.
3.15

Setting event destinations

You can configure audit events to be sent to SNMP trap destinations and Syslog
servers. The events enabled on the Events screen are sent to all the servers
listed on the Event Destination screen.
1. Select Unit View > Appliance > Appliance Settings > Auditing > Destinations
to open the Event Destinations screen.
2. Type the address of up to four management workstations to which this switch
will send events in the SNMP Trap Destination fields, as well as up to four
Syslog servers.
3. Click Save.
3.16

Configuring Adapter Cables

From the switch, you can display a list of the attached adapter cables, as well as
the following information about each cable: eID (electronic ID), Port, Status,
Application, Interface Type, and USB Speed. You can click on one of the cables
to view the following additional information: Switch Type, Boot Version, Hardware
Version, FPGA Version, Version Available, and Upgrade Status.
You can also perform the following tasks: delete offline adapter cables, upgrade
the cable firmware, set the USB speed, or decommission the cables.
To delete offline adapter cables:
1. From the side navigation bar, click Unit View > Appliance > Appliance
Settings > Ports > Adapter cables to open the Appliance adapter cable
screen.
2. Click Delete Offline.
To set the USB Speed (for KVM s4 Adapter USB20-VGA cables only):
1. From the side navigation bar, click Unit View > Appliance > Appliance
Settings > Ports > USB20-VGA to open the Appliance USB20-VGA screen.
2. Select the check box(es) next to the cable(s) that you wish to modify.
38
590-1058-640A