Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
After the success screen appears, click Close. Reboot the managed
appliance to enable the restored configuration. See "KVM s4 Switch Tools"
on page 27.
3.5
Network Settings
Only switch administrators can make changes to the network dialog box settings. Other
users will have view only access.
To configure general network settings:
1.
From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Network > General. The Appliance General Network Settings
screen appears.
2.
Select one of the following options from the LAN Speed drop-down menu:
Auto-Detect, 10 Mbps Half Duplex, 10 Mbps Full Duplex, 100 Mbps Half
Duplex, 100 Mbps Full Duplex, or 1 Gbps Full Duplex.
You must reboot if you change the Ethernet mode.
3.
Select either Enabled or Disabled in the ICMP Ping Reply drop-down menu.
4.
Click Save.
To configure IPv4 network settings:
1.
From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Network > IPv4. The switch IPv4 Settings screen appears.
2.
Select or deselect the Enable IPv4 check box to enable or disable IPv4
mode.
3.
Enter the desired information in the Address, Subnet, and Gateway fields.
4.
Select either Enabled or Disabled in the DHCP drop-down menu.
If you enable DHCP, any information that you enter in the Address, Subnet, and
Gateway fields will be ignored.
5.
Click Save.
To configure IPv6 network settings:
1.
From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Network > IPv6. The switch IPv6 Settings screen appears.
590-1058-640A
3.5 Network Settings
29
Publicidad
Capítulos
Tabla de contenido
