Smart Cards - Fujitsu Control 4 Serie Guia Del Usuario

4. The Video Viewer
To reset all USB devices on the target device:
The USB reset feature resets every USB device on the target device, including the
mouse and keyboard. It should only be used when the target device is not responding.
1. In the Virtual Media dialog box, click Details.
2. The Details View will appear. Click USB Reset.
3. A warning message will appear, indicating the possible effects of the reset.
Confirm or cancel the reset.
4. To close the Details view, click Details again.
Closing a virtual media session
To close the Virtual Media dialog box:
1. Click Exit.
2. If you have any mapped drives, a message is displayed, indicating that the
drives will be unmapped. Confirm or cancel the operation.
If a user attempts to disconnect a virtual media session or an active KVM session
that has an associated locked virtual media session, a confirmation message is
displayed, indicating that any virtual media mappings will be lost.
4.11

Smart cards

You can connect a smart card reader to an available USB port on the client
server and access attached target devices on the switch system. You can then
launch a KVM session to open the Video Viewer and map a smart card.
For all smart card readers, you must use a KVM s4 Adapter USB20-VGA cable.
The smart card status is indicated by the smart card icon at the far right of the
Video Viewer toolbar. The following table describes the smart card status icons.
Table 4.4. Smart Card Icons
Icon Description
A smart card is not in the smart card reader, or a smart card reader is not
attached.
A smart card is in the smart card reader but has not been mapped yet.
A smart card is mapped.
64
590-1058-640A