Publicidad
Assembly Step 3:
A
Slide the Carriage Stop into slot on End Rail (Figure 12).
B
Place Magnetic Carriage Assembly Lever in "release" position.
C
Slide Magnetic Carriage Assembly into slot on End Rail
Section with arrow pointing away from the Power Head.
Assembly Step 4:
A
Attach Rail Strap to End Rail Section with 2 (1/4"-20) Hex
Head Bolts and 2 (1/4"-20) Serrated Flange Hex Nuts
(Figure 13).
B
Tighten snugly but Do Not over-tighten.
Assembly Step 5:
A
Align all Rail Sections so Magnetic Carriage Assembly can
slide freely along length of Rail.
B
Securely tighten all fasteners now. Do Not over-tighten.
Assembly Step 6:
OPEN GREEN PARTS BAG
A
Turn Opener right side up and support Power Head to avoid
damaging the Light Bulb Sockets.
B
Uncoil Limit Switch Wires and retain Twist Ties.
C
Place Switches on Rail with arrows pointing away from
Power Head (Figure 14).
D
Place Close Limit Switch (Brown Wire) 15" from Rail Strap.
Insert (#8-32 x 1") Hex Head Screw into Switch hole and
finger-tighten until later.
E
Place Open Limit Switch (White Wire) 15" from Power Head.
Insert (#8-32 x 1") Hex Head Screw into Switch hole and
finger-tighten until later.
10
C
I
M
H
NSTALL
AGNETIC
A
SSEMBLY ONTO
C
A
R
S
H
TTACH
AIL
TRAP TO
R
S
AIL
ECTION
C
A
R
H
LIGN
AIL SECTIONS AND
T
B
IGHTEN ALL
OLTS
C
I
C
H
NSTALL AND
ONNECT
S
WITCHES
C
ARRIAGE
R
AILS
Toward Power Head
Figure 12 Slide Magnetic Carriage onto Rail
Rail Strap
E
ND
L
IMIT
Open Limit
Switch Assembly
Close Limit
Switch Assembly
Close Limit
Switch
(Brown wire)
Figure 14 Install Limit Switches on Assembled Rail
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
Carriage
Stop
Released
Engaged
Figure 13 Attach Rail Strap
White
Wire
Emergency
Release Knob
Brown
Wire
#8-32 x 1"
Hex Head Screws
Hardware (green bag)
Open Limit
Switch
(White wire)
Arrows point
toward door
#8-32 x 1"
Hex Head
Screws
Magnetic
Carriage
Assembly
Toward door
and header
End Rail Section
End Rail Section
Wire Clips
Wire
Clip
Publicidad
Capítulos
