Publicidad
C
H
Installation Step 5:
OPEN YELLOW PARTS BAG
For sectional doors:
A
Attach Curved Door Arm to Door Bracket with Clevis Pin and
Cotter Pin (Figure 23A).
B
Attach Straight Door Arm to Magnetic Carriage Assembly.
C
Attach both Arms together with 2 (3/8" x 7/8") Hex Head
Bolts and 2 (3/8") Serrated Flange Hex Nuts so overall length
is as short as possible. Securely tighten fasteners.
D
Adjust height of Emergency Release Cord Knob to 6' above
floor:
•
Pull Cord through Magnetic Carriage Assembly Lever
until Knob is 6' from floor.
•
Tie a new overhand knot in Cord at Magnetic Carriage
Assembly Lever.
For one-piece doors:
A
Attach Straight Arm to Door Bracket with Clevis Pin and
Cotter Pin (Figure 23B).
B
Attach Curved Arm to Magnetic Carriage Assembly.
C
Attach both Arms together with 2 (3/8" x 7/8") Hex Head
Bolts and 2 (3/8") Serrated Flange Hex Nuts so overall length
is as long as possible. Securely tighten fasteners.
D
Adjust height of Emergency Release Cord Knob to 6' above
floor:
•
Pull Cord through Magnetic Carriage Assembly Lever
until Knob is 6' from floor.
•
Tie a new overhand knot in Cord at Magnetic Carriage
Assembly Lever.
Do Not skip Step D above!
Failure to comply may leave Emergency Release Knob within
reach of children. If the Knob is pulled with garage door fully
or partially open, garage door may close without warning!
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
A
C
SSEMBLE AND
ONNECT
D
A
OOR
RMS
WARNING
Safe-T-Beam® (STB) Brackets
#10-16 x 1
1
/
"
4
Phillips Hex Head Screw
Hardware (yellow bag)
As short as
possible
Figure 23A Assemble Arms (SECTIONAL)
As long as
possible
Straight
Door Arm
Figure 23B Assemble Arms (ONE-PIECE)
Clevis Pins
Cotter Pins
3/8" x 7/8"
Hex Head Bolts
3/8" Hex Serrated
Flange Nuts
Straight
Door Arm
Curved
Door Arm
Curved
Door Arm
15
Publicidad
Capítulos
