Operating Elements - Iso KEMPER MaxiFil Manual De Instrucciones

6.2 Operating elements

On the front of the MaxiFil controller, you can find the operating elements as well as
connections:
Device button (item 1)
-
This button switches the MaxiFil on and off. The green light ring around the
button shows the faultfree operation of the MaxiFil or the operational
readiness when using a start-stop sensor.
The green light will turn off if there is a fault or malfunction.
The MaxiFil will switch off automatically.
Signal lamp (item 2)
-
The yellow signal lamp shows a fault or a malfunction of the MaxiFil.
These faults are shown with different flashing codes for a visual depiction.
The signal lamp flashes steadily in regular intervals:
- Device maintenance is due, inform KEMPER-Service.
The signal lamp flashes briefly twice in a row in regular intervals:
- The motor protective relay has tripped, inform KEMPER-Service.
The signal lamp flashes briefly three times in a row in regular intervals:
Information: The rotational direction of the fan runner has to match the
Adjusting controller for delay time in start/stop operation (item 3)
-
When connecting a start-stop sensor (optional), you can then adjust the
stopping time of the extraction system after completion of the welding process
for a period of 5 to 60 seconds.
KEMPER MaxiFil stationary - operating instructions- EN
Wrong grid rotation, the fan runner of the fan turns in the
-
wrong direction. To workaround, the CEE plug have to be
replaced with a two phase plug by an electrician.
rotational direction of the rotation direction arrow fitted to
the top of the fan and should be checked.
Technical modifications and errors expected.
- 75 –