Troubleshooting Guide - BH FITNESS H872L Manual De Servicio

The system comprises of a receiver (D)
and a transmitter (chest band) Fig 4.
This telemetric pulse rate system
takes precedence over the Hand-
grip pulse rate system when both
are used together.
See telemetric pulse rate instruction
book.
TEST MEASUREMENTS:
FITNESS
This electronic device is equipped with
a recovery test function. This offers
you the advantage of being able to
measure how long it takes your heart
rate to recover after having finished
the exercise.
exercise leave your hands on the
pulse sensors (R) and press the
«Recovery» button, this will start a
one minute countdown. Only the Time
and Pulse rate function read-outs will
remain displayed.
device will measure your pulse rate
during this minute. The heart rate
recovery time will be displayed on the
Heart rate line.
If, at any time during this minute, you
decide to abandon this test then press
the «Recovery» button and this will
take you back to the main screen.
When the minute is up, the electronic
device will work out the difference and
your fitness rating will be displayed up
on the screen: «F1, F2,..., F5, F6»;
where «F1» is the best (fitness
«Excellent») and «F6» the worst
(fitness «Very Poor»).
Pressing the RECOVERY button will
take you back to the main screen,
where the functions will be in the
same mode as when the test began.
The comparison between the worked
heart rate and the recovery heart rate
provides a fast, simple method of
Upon finishing
The electronic
gauging how fit you are. Your fitness
rating is a guideline that shows you
how fast your heart recovers after
physical exertion. If you exercise
regularly then you will see your fitness
rating improve.
The test does not work unless you
have both hands placed on the
sensors (R) (Hand-grips). In this case
the message «F6» will appear on the
screen at the end of the test.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection
the
cable is connected.
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
Solution:
a.- Finish the exercise or unplug it
from the 220 V mains socket for 15
seconds and then plug it back in.
b.- If the above steps do not help then
replace the electronic monitor.
9V Transformer
Problem: The monitor does not switch
on.
Solution:
a.- Check the 220 V mains connection
b.- Check the output connection from
the transformer to the machine.
c.- Check the cable connections for
the main post.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
THE MANUFACTURER RESERVES
THE RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE.
13
for a particular
TO MODIFY
OF
WITHOUT PRIOR
THE
ITS