Emergency Power Switch; Electric Motors; Motor Protection - SHUPER E-motion Manual Del Propietário

Active pointer indicates the presence of voltage in the circuit. Battery charge level indi-
cator is designed to monitor charge level of the batteries in the process of boat operation.

5.4 Emergency power switch

The electric boat is equipped with an emergency power switch assembly with a bracket
on a cord. Emergency switch cord is designed for an emergency stop of engines (in case
the boatmaster is overboard) and for power shut down. Power supply is turned off and the
engines stop working as soon as the bracket, attached to the end of the emergency cord
is pulled off the emergency switch. When the motors run, the emergency cord must be
securely attached to the wrist of the boatmaster.
Warning!
If the emergency switch cord is not properly connected to the boatmasters,
then in case when the boatmaster falls overboard, the boat will completely go
out of control.
To ensure the safety of boatmaster and passengers it is necessary to always put the
emergency cord bracket on the emergency switch, and the other end of the emergency
cord must be securely attached to the wrist of the boatmaster or to his lifejacket.

5.5 Electric motors

The electric boat is equipped with two noiseless electric motors running synchronously.
The motors are installed on the underwater part of the hull in the transom area.
5.6 Engine protection
Engines protection frame is designed to protect the housing of the electric motors and
propellers from underwater objects and shoals while driving the boat. Protection is made
of stainless steel and is located in the engine installation area.
The frame does not guarantee absolute protection of engines and propellers. Therefore
it is necessary to make every possible effort to avoid collisions of the electric boat with
any underwater objects and shoals.
Attention!
Before leaving the boat or leaving it for stor-
age, be sure that the bracket of the emergency
cord is pulled off the emergency switch and the
power supply is turned off.
Attention!
Do not start the motors without water. Motors
should be immersed in the water to prevent
overheating. Running engines in a dry mode can
severely damage the engine seals and cause
them to break.
29