Descargar Imprimir esta página

Charging; Installation/Removal - Delo YTX9-BS Instrucciones De Uso

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 46
• The container must be left on the battery to drain
for at least 30 minutes. Before removing the acid
pack, make sure that the acid has drained fully
from all the reservoirs into the battery.
• Once the filling process is complete, push the
enclosed black plastic cap strip fully into the
battery openings, keeping it straight. The sealing
cap strip must be completely flush with the
battery housing and must not project at any
point.
• Once the battery is sealed it must never be
opened again. Subsequent opening of the
battery will cause irreparable damage.
• It is not possible or necessary to check or top up
the level of fluid in the battery.
With this type of battery, the lead plates are not
necessarily covered by the acid, as the acid is
completely absorbed by the fleece. This does not mean
that the plates are dry, and on no account must the
battery be topped up with further acid or distilled water.

5.3 | Charging

IMPORTANT!
Risk of damage!
In spite of being factory pre-charged, the battery
must always be 100% fully charged prior to
installation. This must be carried out using
a suitable motorcycle charger. Failure to do
so will shorten the service life of your battery
considerably and may damage the battery.
30
WARNING!
Risk of explosion and fire!
• Never use a car battery charger to charge your
motorcycle battery. They supply a charging
current that is too high and overcharge the
comparatively small motorcycle battery, which
can cause an explosion in the most extreme
cases.
• Only use chargers that are specifically designed
for motorcycle batteries. The charging current
must not be higher than 10% of the battery
capacity (i.e., for a battery capacity of 10 Ah, a
maximum charging current of 1 amp).
• Charging voltages of up to 14.4 V are no problem
for DELO AGM batteries; the optimum
end-of-charge voltage is 14.3 V.
After charging, firmly secure the battery in the clean battery
compartment.

5.4 | Installation/removal

Before you remove the old battery, switch off all the electrical
devices on your motorcycle. Disconnect the earth connection (–)
first of all, then the positive terminal (+), and then remove the old
battery.
After you have ensured that the DELO AGM battery corresponds
to the features of the original battery, install the DELO battery
in the appropriate location. The battery cables are connected in
reverse order – remove the protective sticker and connect the
positive cable to the positive terminal (+) first of all, and then
connect the earth cable (–) to the negative terminal. In this regard,
be sure to use the terminal screws supplied. Prior to connection,
31

Publicidad

Solución de problemas

loading