Automatic Resetting Of The Monitoring Mode; Troubleshooting; Led Operation On The Remote Control - Astralpool Corail protect Manual De Uso

Tabla de contenido

Idiomas disponibles

5.4 AUTOMATIC RESETTING OF THE MONITORING MODE

It is necessary to reactivate the monitoring mode manually when leaving the poolside. Nonetheless, if this

is not done, they system reactivates the monitornig mode automatically after a time delay. The time delay

is set by the installer when the system is installed (factory setting 2 min). It is possible to set the time

delay to: 2 min (for testing only), 30 min, 1 h 30, 2 h, 2 h 30, 3 h or 3 h 30. The time delay is reset to zero

each time a beam is cut off (use of the pool). We can thus consider that the time delay starts as from the

time at which the pool is no longer used, i.e. after the last beam cut-off sequence.

A series of increasingly fast warning beeps is sounded on the integrated siren, and the remote control

buzzer, 60 s before the automatic reset sequence. To restart the time delay sequence, all that is required is

to cut one of the beams or press one of the buttons on the control unit.

6.1.1

CONTROL LET

System status

Normal operation

Mains power supply failure

Infrared Beacon cut off (fog, frost, obstacle, etc.)

Battery charge fault

Internal system power supply fault

Cut-off/short-circuit on a wiring link between

system elements

6.1.2 MONITORING LED

System status

Monitoring activated

Monitoring deactivated

Monitoring alarm memorized

Indicator status

On steadily

Flashes slowly until the problem has been dealt