Error Displays; Specifications - Clarion DXZ948RMP Manual De Instrucciones

9. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display Cause
ERROR 2 A DISC is caught inside the CD deck and is
not ejected.
ERROR 3 A DISC cannot be played due to scratches,
etc.
ERROR 6 A DISC is loaded upside-down inside the
CD deck and does not play.
AMP GUARD The speaker protection circuit is operating.
During this operation, if any volume
operation is performed, the display shows
"AMP GUARD".
"AMP GUARD" sometimes functions when
special test signals are used.
ERROR 2 A DISC inside the CD changer is not
loaded.
ERROR 3 A DISC inside the CD changer cannot be
played due to scratches, etc.
ERROR 6 A DISC inside the CD changer cannot be
played because it is loaded upside-down.
ERROR 2 A DISC inside the DVD changer cannot be
played.
ERROR 3 A DISC cannot be played due to scratches,
etc.
ERROR 6 A DISC inside the DVD changer cannot be
played because it is loaded upside-down.
ERROR P Parental level error
ERROR R Region code error
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
68
DXZ948RMP
Measure
This is a failure of CD deck's mechanism and
consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
1. Turn down sound volume. Function can
also be restored by turning the power off
and on again.
(Speaker volume is reduced automatically
when the speaker protection circuit oper-
ates).
2. If the sound is muted again, consult our
service department.
This is a failure of CD changer's mechanism
and consult your store of purchase.
Replace with a non-scratched, non-warped
disc.
Eject the disc then reload it properly.
This is a failure of DVD mechanism and con-
sult your store of purchase.
Retry or replace with a non-scratched, non-
warped-disc.
Eject the disc then reload it properly
Set the correct Parental level.
Eject the disc and replace correct region
code disc.

10. SPECIFICATIONS

Radio section
Tuning System: PLL synthesizer tuner
Receiving Frequencies:
FM : 87.5 to 108 MHz (0.05 MHz steps)
MW : 531 to 1602 kHz (9 kHz steps)
LW : 153 to 279 kHz (3 kHz steps)
CD player section
System: Compact disc digital audio system
Frequency Response: 5 Hz to 20 kHz (± 1 dB)
Signal to Noise Ratio: 100 dB (1 kHz) IHF-A
Dynamic Range: 96 dB (1 kHz)
Distortion: 0.01%
Note:
• Specifications and design are subject to change without notice for further improvement.
General
Output Power: 4 × 31 W (DIN 45324, +B=14.4V)
Power Supply Voltage:
14.4 V DC (10.8 to 15.6 V allowable),
negative ground
Power Consumption: Less than 15 A
Speaker Impedance: 4 Ω (4 to 8 Ω allowable)
Auto Antenna Rated Current: 500 mA or less
Weight:
Main unit: 1.7 kg
Remote control unit: 80 g (including battery)
Dimensions:
Main unit :
178 (W) × 50 (H) × 155 (D) mm
Remote control unit:
44 (W) × 110 (H) × 27 (D) mm
DXZ948RMP
69