MINOS PLENA Manual De Usuario página 28

PLENA
position. Then fit the upholstery using the hook and loop fasteners.
Tighten the backrest in the chair position and make sure that the
tubes rest on the tube cradle supports so as not to deform the position
of the chair. The upholstery should never be over-tightened so as not
to affect the chair mechanism.
Commode seat
Remove the bolts that fasten the seat upholstery. Fit the bolt in the
commode seat on the front right-hand side of the crossbar. The
commode pan has a hole on the front right bridge that fits on to the
bolt and holds it in place.
Height-adjustable elevating footrest
To raise the footrest, pull it upwards to the desired
height. The footrest automatically locks in position
at different heights. To lower the footrest, press
the lever on the upper end and push down.
The calf support tilts and is adjusted with the handle on the side.
To adjust the height of the footrest, release the side handle and
adjust to the desired height.
This makes it easier to recline the backrest when
the person is sitting in the chair. By pressing the
two handles, the weight of the person's back helps
find the desired position. To raise it, press the two handles again and
the power of the piston helps raise the person.
If the gas piston does not work, tighten or loosen the cable regulator
located on the top of the handle.
Maximum inclination: 40°. The use of anti-tip wheels is recommended.
USER MANUAL
Stump support
It has two bolts and four nuts at the bottom of the
platform so that the support position can be varied
as required.
Both the height and angle can be adjusted.
Reclining backrest with gas
piston
26