Stopping Engine - Koshin SEV-25L Manual De Instrucciones

STOPPING ENGINE

EN
1.Move the throttle lever to the
low speed position.
2.To stop the pump turn off the
engine switch.
Note:Do not stop engine suddenly while
running at high speed.
Should refuel before all fuel consumed
●
in order to ensure a smooth restart.
For storage,drain fuel from the fuel
●
tank,the carburetor.
And start the engine until the remained
fuel in the engine consumed.
Attention:During summer when the engine
is stopped for rest, place on the
horizontally flat, be careful that the
inner packing of tank cap is not
submerged in the fuel as shown
on the right illustration.
If the air hole submerged in the fuel, the fuel
may leak due to the increase inner pressure
in the fuel tank.
1
Low speed
2
engine switch
3
○
×
- 8 -
Operation
After engine start, move the throttle lever to low speed position and warm up the
●
engine for about one minutes. As the engine become warm, smooth acceleration
will be obtained.
Since every part of the engine is not well lubricated at the starting, avoid
●
increasing the engine revolution rapidly.
When the throttle is in full open position, the engine revolution becomes
●
considerably high, and that not only gives a bad effect on the engine life but also
cause the engine failure.
Carburetor adjusting
Revolution of the engine is already adjusted in best condition before dlivery.
Do not adjust revolution unless engine does not work well.
Use the low speed adjusting screw
●
to adjust low speed revolution
Right Turn:increase revolution
Left Turn:decrease revolution
●
Carburetor is already adjusted in best
condition before delivery.
high speed
Low speed
low speed adjusting screw
- 9 -
EN