Tabla de contenido
Publicidad
S P E C I A L F E A T U R E S
OPEN
DIAGRAMA/SCHÉMA/FIGURE 11
OPEN
DIAGRAMA/SCHÉMA/FIGURE 12
15
4. Setting the Strip End Position
When you bind a book, the inserted end of the strip aligns with the edge of
your book that is on your left. We'll call this end of the book the "top" of
the book. Occasionally you'll get a strip that doesn't quite reach the top of
your book, or a strip that goes a little past the top. You can correct this by
EDIT
adjusting the strip's end position.
a.
b.
Pressing the OPEN button shifts the strip to the left; pressing the EDIT
button shifts the strip to the right (figure 11). In other words, if you press
OPEN, the strip will move towards the top of the book. If you press EDIT,
the strip will move towards the bottom of the book.
c.
d.
5. Setting the Wrap for Superstrips™ and Perfectback™ strips
This feature allows you to adjust how the strip wraps around your book.
Usually the Superstrip™is centered on the book's spine, and it wraps
around the book equally on the front and on the back. The Fastback® is
designed to wrap the Perfectback™strip higher around the back than the
front. But you can change this with the "SET WRAP" feature. You can shift
EDIT
the strip so it wraps around more on the front or on the back. Also, if it
isn't wrapping evenly, then you can adjust it so that it does.
a.
choices: SUPERSTRIP WRAP, PERFECTBACK WRAP, and EXIT?. Make
your selection according to the binding style that you are currently using.
b.
WRAP" for Superstrip™, or "DEFAULT WRAP" for Perfectback™.
To change this, use the OPEN and EDIT buttons. Pressing OPEN subtracts
from the setting, shifting the strip towards the back. Pressing EDIT adds to
the setting, shifting the strip towards the front (figure 12).
F A S T B A C K ® M O D E L 1 5 x s U S E R ' S M A N U A L , R E V . C — 7 / 1 9 / 0 2
After selecting the STRIP END feature, the default message is:
You can now adjust the strip end in increments of .008 of an inch.
When you have finished setting the strip end, press BIND.
Insert the correct width strip and begin binding. During binding, the
screen briefly displays the changed strip-end position.
Press BIND to select "SET WRAP." From here, you have three
After selecting the current binding style the default display is "EVEN
DEFAULT SUPERSTRIP DISPLAY
EVEN WRAP
|
DEFAULT PERFECTBACK DISPLAY
DEFAULT WRAP
15
Publicidad
Tabla de contenido
