Connecting An Automatic Gate Opener - Extel WEVP 461 E BIS Instrucciones De Uso

the roadside panel and the monitor
Connecting the monitor to the roadside panel:
•
Terminal "C+"
•
Terminal "C -"
Connecting the monitor to the optional second roadside panel (WEVPPL 461 E BIS):
•
Terminal "S+"
•
Terminal "S -"
In any case, do not double the wires to increase size.
IMPORTANT !
If you try your video door phone before installing it, do not do it with the roadside panel and
the monitor in the same room, otherwise the video door phone will produce a shrill sound
(Larsen effect).
b. Connecting an electric strike or a lock
If an electrical lock or strike is added to the installation, connect it to the terminals
of the roadside panel.
This function can only be used when the screen is switched on.
It is normal that the image switches off one moment following the control of the gate opener.
It is advisable to use an EXTEL strike or lock with call memory, it will remain unlocked after the end
of the electric pulse.
c. Connecting an automatic gate opener
Connect it directly to the terminals
supplies a current-free "dry" contact to connect to the "push button" control of your automatic
gate opener.
This function can only be used when the screen is switched on.
It is normal that the image switches off one moment following the control of the gate opener.
Distance between
From 1 to 25 metres
Up to 100 meters
of the monitor to the terminal
of the monitor to the terminal
of the monitor to the terminal
of the monitor to the terminal
Type of cable to use
"C+"
of the roadside panel.
"C -"
of the roadside panel.
"C+"
of the roadside panel.
"C+"
of the roadside panel.
at the back of the roadside panel. The roadside panel
5EN
Two 6/10° wires
Two 1.5 mm2 wires
at the back