Restraint System 50 H; Opening And Closing - SCHUBERTH C3 Manual De Uso

C. THE HELMET
9. RESTRAINT SYSTEM
The restraint system of the C3 consists of a chin strap that is additionally
secured to the rear of the helmet shell with neck straps.
CHIN STRAP WITH MICRO-LOCK RATCHETING LOCK
The C3 is delivered with a ratcheting lock. With this
locking system it is possible to ensure that the chin
strap fits easily and properly adjusted to your head
each time you put the helmet on.
ADJUSTING THE CHIN STRAP
To change the length of the chin strap, increase or
reduce the amount of strap that is pulled through the
metal buckle. Adjust the length of the chin strap so that
it sits firmly but comfortably under the chin. Use the
retaining loop to fix the end of the strap to the comfort
chin strap underlay.
50
Warning:
Take care when adjusting the chin strap to ensure that the helmet
cannot be pulled forward off the head when the strap is engaged.
Check the adjustment of the chin strap leng th regularly.

Opening and closing

To do up the chin strap, push the ratcheting tongue into the lock mechanism
click by click until it fits snugly. If the strap is too loose on the chin, push the
ratcheting tongue one increment further into the mechanism. When adjusting
the chin strap, make sure that it is not irritating but is still tight against the
chin at the same time. Undo the chin strap by pulling up the red strip on the
ratcheting lock to release the locking mechanism. Then pull the ratcheting
tongue out of the locking mechanism.
Warning:
Never ride before checking that the chin strap is properly fastened,
correctly adjusted and positioned. If the chin strap is not properly
adjusted or fastened, it is possible for the helmet to come away from
your head in the event of an accident.
Warning:
The chin strap must always be done up when riding. Never unfasten
the chin strap while riding.
EN
51