Ice Maker Installation; Unpacking; Installing The Adjustable Feet - Franklin Chef FIM200 Manual Del Usuario

Máquina de hielo comercial automática
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking

Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice
maker.
Remove tape and glue from your ice maker before using,
·
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
·
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your ice maker.
·
Leave lowermost foam panel in place until after the adjustable feet are attached.
Cleaning before use
After you remove all tape and glue from the machine, clean the inside of your ice maker before
using it. See Interior Cleaning in the Cleaning and Maintenance section.

Installing the adjustable feet

At least two persons are required to install the adjustable feet.
You will find four adjustable feet packed in the ice storage bin. To install, tilt one side of the unit
and screw in two adjustable feet, as illustrated. (IMPORTANT: Do not tilt the unit more than 45
degrees.) Then tilt the other side and screw in the remaining two feet.

Ice Maker Installation

Lower foam panel
7

Publicidad

Tabla de contenido
loading

Tabla de contenido