Maintenance - EdilKamin DAISY Instalación Uso Y Mantenimiento

Before performing any maintenance, disconnect the applian-
ce from the mains.
Regular maintenance is required for the boiler-stove to fun-
ction correctly.
Any problems resulting from lack of maintenance will imme-
diately void the warranty.
When cleaning is necessary, the message "Clean - exchan-
ger" will appear on the panel if further cleaning is necessary.
NOTE: The DEALER, upon commissioning, sets the kg va-
lue of consumed pellets; after which, the message "SERVICE
UTE" will appear on the display. The boiler-stove continues
operation, but the end client is invited to perform careful
maintenance, described above and explained by the DEA-
LER during commissioning, to the extent of his abilities.
Once the maintenance work has been performed, press and
hold down the "M" button on the radio remote control for at
least 5 seconds to delete the message displayed on the screen
(this operation must be performed with the thermo-stove
off).
DAILY MAINTENANCE
Operations must be performed when the boiler-stove is off,
cold and unplugged from the power supply.
Cleaning should be carried out with the aid of a vacuum clea-
ner (see optional page. 56), the whole procedure takes up a few
minutes.
• Open the door, remove the combustion chamber (1 - g. A) and
empty the residue out into the ash pan.
• Scrap the combustion chamber with the spatula provided,
removing any obstructions in the openings.
• DO NOT EMPTY THE RESIDUE OUT INTO THE PEL-
LET HOPPER.
• Take out and empty the ash (2 - g A) pan into a reproof con-
tainer (the ash may still contain hot parts and/or embers).
• Vacuum clean the inside of the replace, the re surface, the
compartment around the chamber where ash falls, and the ash
pan.
• Vacuum the combustion chamber holder, clean the edges where
the combustion chamber is lodged into its seat.
• Clean the glass, if necessary (when cold).
AT LEAST ONCE A DAY ACTION THE CLEANING
BRUSHES OF THE EXCHANGERS (*), EVEN WHILE
THE STOVE IS LIT, USING THE GLOVE PROVIDED:
- Proceed by shaking the cleaning handle positioned under the
grill of the top ( g. B).
NEVER SUCTION HOT ASH, as this could damage the
suction device and possibly cause a re.
ATTENTION:
MAKE SURE THE ASH PAN IS CORRECTLY POSITIO-
NED IN ITS HOUSING (2 g. A)
We remind you that using the stove without cleaning the
melting pot, may cause a sudden ignition gas inside the com-
bustion chamber with the consequent breaking of the glass
WEEKLY MAINTENANCE
• Clean the hearth (with the tube brush).
• Vacuum the pipe near the electric coil (3 - g A).
• Remove the ceiling (4 - g. C) and tip the residue into the ash
drawer (2 - g. A).

MAINTENANCE

g. A
g. B
g. C
g. D
- 51
-
1
2
*
3
4