Sinmag Europe RV01 Manual Del Usuario página 4

ENG
3. INSTALLATION
CAUTION: Do not allow any part of your body to be under the unit
during the lifting process. Keep everyone clear from the unit if it
should fall.
CAUTION: To reduce the risk of fire, the unit is to be mounted on
floors of non- combustible construction with non-combustible
surface finish, keep area around the unit clear of combustibles.
CAUTION: Allow the unit to run only in proper work area with
adequate light and space, do not obstruct any ventilation opening
on the unit.
• Retain all shipping materials until you are certain that the oven has not
been damaged (either externally or internally) during shipment. It is solely
customer's responsibility to report any shipping damage to the freight
company.
• Check the area where the oven is to be installed for the following:
• The ground must be firm, level and fire-proof, make sure there are no
obstacles and debris under the floor of the oven.
• The area must be drafty and clear of all combustibles, make sure all the
ventilation openings on the oven are unobstructed.
• The clearance above the oven should allow the installation and mainte-
nance of the assemblies on top of the oven, a minimum clearance of 0.5m
at the sides and back of the oven is required.
• The installation location must allow adequate clearance for servicing and
for the proper operation of the loading door.
• It is necessary to prepare the room for all connections to the oven: elec-
tricity and water shutoffs are required within a reasonable distance to the
oven, clear access to the exterior of the room for exhaust duct is also
needed.
Unloading the oven shall be done with safety in mind. The use of proper un-
loading equipment is strongly recommended. When using a forklift, make sure
the lifting capacity of the forklift is adequate and the forks do not damage any
parts of the oven. Prior to unpacking, move the oven as near to its intended lo-
cation as possible. Existing packaging will help protect the oven from physical
damages.
4
SINMAG EUROPE BVBA