Easy Setup; Normal Operation - Dal Zotto BRUNELLA ELITE Manual Del Usuario

EASY SETUP

The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet. This ratio may change without altering
pellet quality. By using the EASY SETUP function, it is possible to change the calibration of the volumetric weight by increasing or decreasing
the preset values.
In the stove program, the available values range from "– 3" to "+ 3"; all stoves are calibrated during production with the optimal value, which
is 0.
If there is an excessive deposit on the burn pot, access the EASY SETUP program and lower the value to "- 1"; then wait until the next day and
if there is no improvement, lower it again down to a limit value of "- 3".
Instead, if it is necessary to increase the calibration of the volumetric weight of the pellet, change the factory value from "0" to "+ 1, + 2, + 3"
as required.
EXCESSIVE PELLET DEPOSIT IN BURN POT
-3 -2
THIRD SECOND
DECREASE DECREASE
RANGE IF THE RANGE IF
FIRST TWO ARE THE FIRST IS
INSUFFICIENT INSUFFICIENT
CONTROLS PROCEDURE
Š Press key 6.
Š Press key 3 until EASY SETUP appears and con rm by pressing key 6.
Š Use keys 4 -5 to set the range.
Š Press key 6 to con rm and key 1 to scroll back through the menus until the initial page.
N.B.: IF THESE ADJUSTMENTS DO NOT SOLVE THE PROBLEM OF PELLET DEPOSITS IN THE BURN POT, PLEASE CONTACT
YOUR LOCAL SERVICE CENTRE.

NORMAL OPERATION

-1
FIRST DECREASE
OPTIMAL FACTORY
RANGE
VALUE
(TEST FOR 1 DAY)
ENGLISH
MINIMUM PELLET DEPOSIT IN BURN POT
0 +1
FIRST INCREASE
RANGE
+2 +3
SECOND
THIRD INCREASE
INCREASE
RANGE IF THE
RANGE IF
FIRST TWO ARE
THE FIRST IS
INSUFFICIENT
INSUFFICIENT
59