Displays; Alarms - Dal Zotto BRUNELLA ELITE Manual Del Usuario

DISPLAY
OFF
Generator o
START
The START phase is in progress
PELLET LOADING
Continuous pellet loading is in progress during the ignition phase
ON
The ignition phase is in progress
PREPARATION
The preparation phase is in progress
WORK
The normal work phase is in progress
MODULATION
The generator is operating at the minimum speed
FINAL CLEANING
The nal cleaning is in progress
STAND BY
Generator o waiting to turn back on due to the thermostat.
A new ignition is attempted when the generator has just be switched o . When the generator is switched o , it is
COOLING
necessary to wait for the fumes motor to switch o completely, then clean the burn pot. Only after performing these
STAND BY
operations will it be possible to switch the generator on again.
BLACK OUT
The generator is cooling down after a power failure.
STAND BY After the cooling phase, it will turn back on automatically
BLOW
The automatic blow is active
This indication means that you have 60 seconds to close the hatch/door and the pellet lid.
CLOSE HOPPER
Once 60 seconds have passed, during ignition the stove will go into "DEPR ALARM" mode, while during normal
STOVE DOOR
operation the stove will go into "COOLING STAND BY" mode before automatically restarting when the conditions are
satis ed (cold stove, etc.).
DISPLAY
Indicates the presence of an alarm.
FUMES MOTOR
Fumes motor failure
FAULT
FUMES PROBE
Fumes probe fault.
HOT FUMES
High exhaust temperature
The pellet hopper is empty.
NO
Unsuitable pellet loading calibration.
IGNITION
Thermostat bulbs tripped.
The pellet hopper is empty.
NO FLAME
Pellets not loading.
The gear motor is not loading pellets.
The door is not closed properly.
The ash drawer is not closed properly.
DEPR ALARM
The combustion chamber is dirty.
The fumes exhaust pipe is blocked/dirty
NO
No power during the ignition
IGNITION BLACK OUT phase.
ALARM
Abnormal operation of pellet loading.
COMMAND AUGER
70

DISPLAYS

ALARMS

EXPLANATION
ENGLISH
REASON
SOLUTION
On: indicates the presence of an alarm
The alarm can be reset only if the fumes motor has stopped and 15
minutes have passed since the alarm was displayed, by pressing key 1
for 3 seconds.
Contact the service centre
Contact the service centre
Check pellet loading (see "Easy setup"); if the problem is not solved,
contact a quali ed technician.
Check for the presence of pellets in the hopper.
Adjust the pellet ow (see "Easy setup").
Check the procedures described in the "Ignition" chapter.
Check the thermostats with bulbs (see chapter on Resetting)
Check for the presence of pellets in the hopper.
Adjust the pellet ow (see "Easy setup").
Check that the door closes hermetically.
Check that the ash drawer closes hermetically.
Make sure that the fumes pipe and the combustion chamber are clean.
Turn the stove off by pressing key 1 and repeat the procedures
described in the "Ignition" chapter.
Other restoration operations must be performed by
an authorised technician.
Contact the service centre