Gas Connection; Electrical Connection - Angelo Po 090BM1G Manual De Uso

GAS CONNECTION

Important
Those authorised to carry out this opera-
tion must have experience acquired and
certified in the specific sector, must make
the connection to the proper standards,
and must comply with all the relevant regu-
lations and legislation. Once the connec-
tion has been made, before the appliance is
put into operation a general check must be
made to ensure there are no gas leaks.
To make the connection, connect the mains line to
the appliance's connection pipe, fitting a shut-off
tap (A), to allow the gas supply to be cut off when
necessary.

ELECTRICAL CONNECTION

Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
230 V/1 N.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit- breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Pull off the knob (B).
3 - Undo the scr ews (C) and remo ve the control
panel (D).
4 - Remove the guard (E).
5 - Connect the circuit-breaker (A) to the terminal
board (F) of the appliance as shown in the dia-
gram and in the elect rical system diagram at
the back of the manual.
A
Important
The tap (A), not supplied with the appliance,
must be installed in an easily accessible
position and its status (on or off) must be
obvious at a glance.
A
B
C
C
D
Use a flexible cable with at least type H07RN-F
characteristics, rated for an operating temperature
of at least 80°C.
Important
When connecting, take care to connect the
neutral and earth lines.
6 - Replace the guard (E).
7 - Tighten the cable gland (G).
8 - Replace the control panel (D) on completion of
the operation.
- 17 -
IDM-39603612100.tif
F
E
G
IDM-39615801400.tif
English
IT
GB
DE
FR
ES