Personal Safety - TRAPP TRC-40 Manual De Instrucciones

2 - Electrical safety (TRC-40)
Do not expose the equipment to either
 
rain or humidity. Install the equipment in a
dry place, protected from weather conditions.
Water inside the equipment can damage the
electric circuit of the motor, besides increasing
the risk of an electric shock.
Before installing your equipament, make
 
sure the electrical voltage in your property
coincide with the electric motor. Connecting
electrical cables in a different voltage will cause
immediate motor burnout resulting in a loss of
warranty.
For your safety, ground the equipment.
 
Failure to do so may result in an accident,
electrical shock or personal injury.

3 - Personal safety

Beware with what is going on and use
 
common sense
equipment. Do not use it when you are tired,
distracted or under the influence of drugs, alcohol
or medicine. A slight distraction may result in a
serious injury.
Do not leave shredder running and/or
 
unattended.
Do not turn on shredder if feeding funel
 
is open. In this position the blades will lock.
Wear protection equipment. Always wear
 
goggles. Wearing protection equipment like
gloves, shoes, and ear plugs increases your
protection and reduces the risk of an accident.
Wear proper clothes. Wear neither loose
 
clothes nor jewelry.
Do not be overconfident. Keep your feet on
 
the ground to maintain balance while you are
carrying or using the crusher.
Take precautions against accidental running.
 
Make sure the switch is set to "off" before
plugging the equipment in. Failure to do so may
cause a serious accident (TRC-40).
36
when operating the
Remove all objects before turning on the
 
equipment. A tool or any other object stuck
in the movable parts of the equipment may
result in an injury.
4 - Use and care
Do not overuse the equipment. Use it in the
 
right way and for the purposes described in
this manual for better performance and safety
while working.
Do not grind rock, glass, metals, plastics,
 
chemical products or other items that can
damage the shredder mill.
Do not allow
 
familiarized with the equipment to use it.
The equipment may become dangerous in the
hands of people not familiar with its operation.
Should the shredder not achieve its full
 
power capacity, contact service dealer or
an electrician to verify the condition of your
electric power source to avoid motor burn-out
.
by overload
If the engine does not start (locked) when the
 
crusher is turned on, turn it off immediately,
unlatch the cutting assembly, and then try to
switch it on again.
Verify that the blades are running clockwise.
 
Should blades be running counterclockwise,
contact service dealer or an electrician to invert
direction of rotation (TRC-40).
Do not use the equipment if the switch
 
does not turn on/off. The equipment can not
be controlled if the on/off switch is damaged.
A defective switch shall be immediately
repaired (TRC-40).
Disconnect the circuit breaker, remove the
 
mains plug or the gasoline engine spark
plug cable before making any adjustments
or changing blades, this will prevent future
accidents.
Never put the equipment away with gasoline in
 
the tank (TRC-50). If necessary, keep the engine
running until it turns off due to lack of gasoline.
www.trapp.com.br
people that are not