TRAPP TRC-40 Manual De Instrucciones página 40

Image merely illustrative.
4. Check the motor circuit diagram for the
connection scheme according to mains
voltage, and splice the motor wires to the
crusher mains wires using appropriate
connectors.
The coconut shredder TRC-40 / TRC-50 is
 
intended to shered green coconut or dry in
order to execute the defibering for composting
or use it as raw material for other applications.
If coconuts are left aside for too long after
 
being opened and the water consumed,
the coconut fibers end up hardening; this
condition requires special care while feeding
1. Before crushing, make sure that the residues to be
crushed do not contain non-crushable objects such
as stones, glass, clay, sand, and other items.
2. Activate the motor and wait to reach the
maximum speed.
3. P
lace the green coconuts one by one in
the feeding funnel of the shredder (we
recommend shredding coconuts without
water). Overloading the feed hopper impairs
machine productivity, that can reach up to
1,000 kg/h.
4. Minor pieces of coconut can pass through the blade
assembly if they are fed separately, just as larger
pieces may not pass through the feeder hopper,
40
5. After connecting the wires, with the crusher
Cord holder
Note:
made, and that bare wires do not touch each other
or the terminal box to prevent short circuit and risk
of electric shock for the operator. This electrical
connection must be performed by qualified
professionals.
What you Can Shred
Operation
5. Check the crushed material outlet spout while
6. When releasing coconuts into the feeder hopper,
feed hopper closed, turn on the motor to
check the rotation direction, if the rotation
is correct, close the terminal box with the
cover. If the rotation is not correct, follow the
instructions on the motor plate to reverse the
wire connection; test again, and then close
the terminal box with the cover.
Make sure that this connection is correctly
the machine to avoid cluttering. If the crushed
coconut is run into the crusher again to obtain
better shredding, the feed of crushed material
into the machine should be controlled to
avoid cluttering. The crushed material size
and productivity may vary according to
coconut conditions, their size, and how the
operator works.
case in which you can select the coconut size while
feeding the machine to achieve the desired results.
working, if necessary turn off the crusher to clear
crushed material from the outlet spout. This
situation may occur when the crushed coconut
fiber is wet, or if the coconut is in decomposition
state.
make sure that they do not get stuck in the blade
assembly, as this will prevent you from crushing
more material; in this case turn off the crusher,
remove the coconut blocked in the cutter assembly,
and resume normal work.
www.trapp.com.br