Cutting Blades Maintenance - TRAPP TRC-40 Manual De Instrucciones

www.trapp.com.br
4
7
8
9
12
11
13
Image merely illustrative.
To remove the blades, proceed as follows:
Remove the bolt (1), the plain washer (2) the
 
upper blade (3), the intermediary blade (4)
and the intermediary blade (5).
Next, remove the separator of 16 mm (6), and
 
the intermediary blade (7).
Then remove the hexagon bolts (8), the lock
 
washer (10), the hex nuts (11), the blade
holder (12) and the lower blade (9).

Cutting Blades Maintenance

1
2
3
5
6
10
Check the shank (13) alignment before
 
completing the assembly of the blade
assembly, if necessary align the shanks
to avoid excessive vibration of the cutter
assembly.
Assemble the blades in the same direction
 
and position as shown in the side picture to
ensure that the cutter assembly is working;
incorrectly mounting the blades may damage
the equipment and cause loss of warranty.
Before turning on
assembling the blades, manually rotate the
cutter assembly and check that it runs clear
from any part of the crusher. If you notice
an excessive vibration when starting the
crusher, check the blade assembly step; if
you still have problems, call a TRAPP Service
Technician.
Note: Blades should be replaced when the sharp area
advances by 20% of the cutting area.
Faca A ada
Sharp knife
Faca A ada
Image merely illustrative.
ATTENTION!
Use
!
TRAPP ORIGINAL
PARTS.
TRAPP does not undertake
responsibility for eventual
damages caused to the
equipment, neither for
accidents that may occur due
to the use of non-original parts.
the machine after
Faca Gasta
Blunt knife
Faca Gasta
43