TRAPP TRC-40 Manual De Instrucciones página 38

Use the equipment according to the
 
instructions
consideration the working conditions and
the service to be done.
Clean shredder periodically to avoid buildup of
 
residue.
Use of the equipment for activities not
 
described in this manual may result in
hazardous situations and equipment damage.
The TRC-50 is equipped with a four-cycle
 
explosion motor - It does not use oil mixed
with the gasoline.
The engine do TRC-50 leaves the factory
 
without oil and gasoline.
Image merely illustrative.
Attach the feeding funnel (1) in the body (2),
 
pass the locking pin (3) through the holes of the
feeding funnel (1) and the body (2).
38
in this manual. Take
Feeding Funnel Assembly
7 6
5
3
Spare parts - Always call TRAPP technicians
 
for spare parts and maintenance services.
in
Attention!
Frequently check if all screws are well
tightened.
Always keep blades sharp to ensure good
equipment performance.
Attention!
Whenever cleaning or servicing, make sure
the equipment is off and the blades are still
as they continue to move for some seconds.
Fix the locking pin (3) with the cotter pin (4).
 
1
Then lock the feed hopper (1) using the plain
 
washer (5), the pressure washer (6) and the
4
hand screw (7) in each of the 3 holes to fasten
the hopper to the body.
2
Note:
To avoid physical damage to the equipment,
never turn the equipment on if the feed hopper is
without the locking pin and the 3 hand screws.
www.trapp.com.br