Installation Of Cables - Rechner Sensors EasyTeach P3 Manual De Instrucciones

Electrical connection
Electrical connection EasyTeach by Wire (ETW)
EasyTeach versions have two modes:
By connecting the Teach input with UB+, the Teach mode is activated
By connecting the Teach input with GND, the Operating mode is activated
Electrical connection EasyTeach by Button (ETB) / Magnet (ETM)
2 x Normally Open
A1
A2
S1 0 1
S2 0 0
A1 open closed
A2 open open
LED
0 = Medium / object not detected
1 = Medium / object detected
Attention:
For inductive loads, a corresponding protective circuit (e.g. freewheeling diode) must be provided.

Installation of cables

Wiring of the sensor should be routed separately or screened from heavy conductor lines, as in extreme
cases inductive peak voltages can destroy the sensors despite the integrated protective circuit. Screened
cable or twisted lines are recommended, especially for longer cable runs > 5 m.
Units with strong fields nearby, e. g. high power walkie-talkies, or noise sources in the lower frequency
range, e. g. long, middle or short wave transmitters should not be operated close to the sensors or additional
measures have to be taken in order to eliminate incorrect operation.
26
+ Teach
- Opertating
0 1 0
1 1 0
open closed closed
closed closed closed
2 x Normally Closed
1 0 1
0 1 1
open closed open
closed open open
+ Teach
- Operating
Antivalent*
0 1
Not available
open closed
closed open
*Delivery configuration