Cancelling The Surround Mode For Stereo Operation; Adjusting The Current Channel Level - Sherwood R-807 Instrucciones De Funcionamiento

R-807 NETWORk AV RECEIVER
Cancelling the Surround mode for Stereo
Operation
1
Press STEREO.
• Depending on the input signal format, either
the stereo mode or the 2CH downmix mode is
selected.
2
To cancel either the stereo mode or the 2CH
downmix mode, press the SURROUND buttons
to select the surround mode.
Note
• 2 CH downmix mode allows the multi-channel
signals encoded in DTS or Dolby Digital format,
etc. to be mixed down into 2 front channels and
to be reproduced through only two front speakers
or through headphones.
• If headphones are plugged in to the main unit
while playing the multi-channel digital signals
from DTS or Dolby Digital sources, etc., it will
enter the 2CH downmix mode automatically.
30

Adjusting the Current Channel level

After adjusting each channel level with test tone, adjust
the channel levels according to the program sources or
to suit your tastes.
1
Press the CHANNEL LEVEL button.
2
Select the desired channel by pressing  or .
• Each time the buttons are pressed, the
corresponding channel changes as follows:
FL [ FHL]  C [ FHR]  FR 
SR ( SBR  SBL)  SL  SW
( ) : Possible when the surround back channel
is set to "2ch" or "1ch".
[ ] : Possible only when the front height
speaker is not set to "NO".
Note
• Depending on the speaker settings (such as "NO")
and surround mode, some channels cannot be
selected.
3
Adjust the level of the selected channel as
desired by pressing  or .
4
Repeat the steps 2 and 3 to adjust each channel
level.