Setting The System Setup; Amp Assign; Automatic Power Control; Network Standby Control - Sherwood R-807 Instrucciones De Funcionamiento

Receptor a/v con conexión de red
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

R-807 NETWORk AV RECEIVER

Setting the System Setup

AmP Assign

The surround back channels' power amplifier can drive
surround back speakers, front height speakers, and
the ROOM 2 speakers. Depending on the purpose of
the speakers, you should assign the power amplifier
accordingly. For details, see "Connecting Speakers" on
page 13 and "Connecting Multi-Room" on page 23.
menu item
Drives the surround back speakers
Surround Back
when connecting the SURROUND
BACK channels to them.
Drives the front height speakers
Front Height
for Dolby Pro Logic IIz playback.
Drives the ROOM 2 speakers for
Room2
ROOM 2 playback.

Automatic Power Control

You can set the standby time for the system to be
turned off. The default setting value is 4H.

Network Standby Control

You can set whether the main unit can be turned on
from other network devices.
menu item
Enables the network standby
ON
function.
Disables the network standby
OFF
function.
44
After you have installed this receiver and connected
all the components, you should adjust the speaker
settings for the optimum sound acoustics according to
your environment and speaker layout. Whenever you
change speakers, speaker positions, or the layout of
your listening environment, you should also adjust the
speaker settings, too.

Auto Setup

Description
Auto Setup lets you avoid the more difficult listening-
based speaker setup and achieve good surround
sound automatically. Auto Setup provides the optimum
listening environment for the listening position in your
room. When performing the Auto Setup procedure,
you do not need to perform the Speaker Configuration,
Speaker Crossover, Speaker Distance and Channel
Level setup procedures.
1
2
Description

Setting the Speaker Setup

Check that the speakers are firmly connected to
this receiver.
• If your subwoofer has a volume control and
crossover frequency, set the volume halfway
and set the crossover frequency to the
maximum or the low pass filter off.
Connect the supplied microphone to the SETUP
MIC jack on the front panel.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido