Legrests - Adjusting The Angle; Calf Pads; Calf Pads - Adjusting The Height; Anti-Tip Brackets - Days Solstice Comfort Manual De Instrucciones

Solstice Comfort – 15.09.2010
8.7.3 Legrests – Adjusting the angle
A
1. Pull lever (A) forward and hold.
2. Adjust legrest to the desired angle.
3. Let go of the lever.
The legrest remains at the adjusted angle.
8.8

Calf pads

8.8.1 Calf pads – Adjusting the height
1 × Allen key (4 mm)
A
1. Unscrew nut (A),
while securing the hexagon socket screw against turn-
ing.
2. Remove hexagon socket screw.
3. Adjust the calf pad to the desired height.
4. Insert hexagon socket screw into the hole.
5. Place spring washer.
6. Refit nut (A) and tighten it firmly.
7. Secure the hexagon socket screw against turning.
8.9

Anti-tip brackets

Note
• Push the anti-tip bracket into the fitting tube and fas-
ten by means of the locking pin.
• To remove, pull out the locking pin and remove the
anti-tip brackets from the fitting tube.
8.9.1 Anti-tip brackets – Adjusting the height
1. Loosen locking pin (A).
2. Adjust anti-tip bracket (B) to the desired height.
3. Fasten locking pin (A).
4. Adjust the second anti-tip bracket in the same man-
ner.
Risk of accidents!
The anti-tip brackets are not installed correctly unless
locking pins (A) are inserted correctly.
Following adjustment, check the anti-tip brackets to en-
sure firm seating.
Note
The further down the anti-tip brackets are adjusted, the
higher the degree of safety against tipping backwards.
However, this does reduce the manoeuvrability of the
wheelchair.
GB – 11
A
B