Wheelchair - Assembly; Getting In And Out Of The Chair; Restraining Belt; Adjusting Length Of Restraining Belt - Days Solstice Comfort Manual De Instrucciones

Solstice Comfort – 15.09.2010
4.2 Wheelchair – Assembly
1. Attach drive wheels, see page 16.
2. Attach Anti-tip brackets, see page 11.
3. Insert seat cushion, see page 8.
4. Insert headrest, see page 9.
5. Adjust backrest, see page 8.
6. Adjust legrests, see page 10.
5

Getting in and out of the chair

The physical condition and degree of disability determine
the most sensible method for getting in and out of the
wheelchair.
If you have any questions, please consult your therapist
and/or specialised dealer.
Risk of accidents!
Prior to getting in or out of the wheelchair, ensure that it
is standing on a solid, level and nonslip surface.
Please observe the following prior to getting in or
out:
• Apply wheel locks, see page 7.
• Open restraining belt.
• Do not step on the footplates when standing up or
getting in and out of the wheelchair.
• Flip up the footplates of the legrests, see page 5
or
• remove the legrests, see page 5.
• If necessary, remove side panels, see page 10.
5.1

Restraining belt

5.1.1

Adjusting length of restraining belt

Adjust the belt strap of the catch to the required length.
Tighten the loose-hanging end of the belt strap and fas-
ten it with the holder.
5.1.2

Locking restraining belt

Press the catch of the restraining belt into the lock until it
is latching hearable.
5.2

Footplates

5.2.1 Footplates – Flip up
A
1. Turn the calf pads (A) outwards.
2. Grab footplate (B) on the side and flip up towards the
legrest tube.
5.2.2
Grab foot plate (B) on the side and flip down.
5.3
5.3.1
1. Press legrest lock (A) and keep it pressed.
2. Swing out legrest.
3. Remove legrest upward out of the fitting tube.
5.3.2
B
Footplates – Flip down
B

Legrests

Legrests – Remove
A
Legrests – Inserting and swinging in
GB – 5