Weighing; Interface - Adam Equipment CPW plus 35 Manual De Instrucciones

EN
To select the weighing unit press the [Unit] key to move form one unit to
another. The weighing unit must be enabled by the users beforehand
(see section 13.1.3). If a unit is disabled it cannot be selected by using
the [Unit] key.

10.5 WEIGHING

 When the scale is at zero, place an item to be weighed on
the platform. The display will show the weight in the unit
selected previously. The weighing result can be viewed in
other enabled units using the [Unit] key.
 If a container is used, this can be tared as described in 10.3.
The scale then shows the net weight of the material added.
11.0 RS-232 INTERFACE
The CPWplus scales come with a bi-directional RS-232 interface.
U
Interface parameters are:
RS-232 output of weighing data
ASCII code
Selectable Baud
Selectable data bits
Selectable Parity
U
Normal OutputU : (See section 13.1.7)
add: A
G/W: + 2.00 kg
<cr><lf>
<cr><lf>
<cr><lf>
add: A
N/W: + 1.00 kg
<cr><lf>
<cr><lf>
<cr><lf>
C ontinuous OutputU :
U
ASNG/W + 0.00 xx
ASNG/W + 0.51 xx
ASNG/W + 2.99 xx
<cr><lf>
The scale can be controlled by a computer using the following
commands. The commands must be sent in upper case letters,
i.e. "T" and not "t". The input and output formats are as given below.
© Adam Equipment Company 2014
C onnection details are:
U
Connector: 9 pin D-subminiature socket
Pin 3 Output
Pin 2 Input
Pin 5 Signal Ground
G/W is Gross Weight
N/W is Net weight
(See section 13.1.7)
A is communication address set by the user,
S stands for stable, N for no error G/W for
gross weight, xx for the chosen unit
12 9009RevD2-March 2017