Setting Up; Setting Up The Standard Cpwplus Series - Adam Equipment CPW plus 35 Manual De Instrucciones

EN
3.3

SETTING UP

3.3.1 SETTING UP THE STANDARD CPWplus SERIES

1> Remove the parts from the packing
carefully. Place the base on a rigid surface.
Place the Stainless Steel pan on the base, if it
not already assembled.
3> Where applicable connect the cable
attached to the base to the connector at the
rear of the indicator. Tighten the ferrule to
secure the cable.
Connector
on the
Indicator
Connector
attached to
the cable
NOTE: When moving the scale, take care to
prevent bending of the cable and connector
too much as over a period of time this can
weaken the wires in the connector and
cause malfunction.
MOUNTING THE INDICATOR-
following 3 ways. To adjust the angle of the indicator, use the two thumb screws on the side of the
bracket that connects the indicator.
1. Place it on the work bench- Simply place the indicator attached to the bracket on the work
bench at an angle.
2. Attach it to the base of the scale- There are two thumb screws on the base (opposite to the
Power input and RS-232 ports). Remove them from the base and use them to attach the
bracket to the base.
3. Mount it on the wall- Use two suitable screws (not supplied) to fix the bracket to the wall.
© Adam Equipment Company 2014
Ferrule
The indicator attached to the bracket can be mounted in the
2> The indicator is separately packed and
comes attached to a bracket with the help of
two thumb screws.
Caution: Do not install the thumbscrews
without the bracket being in place.
Bracket
To adjust the angle of the indicator, use the
two thumb screws on the side of the bracket
that connects the indicator.
4> Power can be supplied using the mains
power adapter or by fitting batteries inside the
scale unit (6 x AA size).
Remove the
compartment under the scale. Install six AA
alkaline batteries as shown below.
Note: Rechargeable (1.2volt) batteries will not
work, only alkaline batteries should be used.
Note: The backlight should be set to OFF to
prolong the life of the batteries. See section
13.1.2
6 9009RevD2-March 2017
Thumb Screw
cover from the battery
6 X "AA" Alkaline