Setting Up The Cpwplus W, M & L Series - Adam Equipment CPW plus 35 Manual De Instrucciones

EN
3.3.2 SETTING UP THE CPWplus W, M & L SERIES
1
Remove the parts from the packing
carefully. Place the base on a rigid floor.
Level the base using the four adjustable
feet.
Adjustable feet
3
The indicator is separately packed and
comes attached to a bracket with the
help of two thumb screws. As shown
above.
The CPWplus –W scales include a
bracket to support the indicator. Secure
the bracket to the base using the 2
screws supplied.
To adjust the angle of the indicator, use
the two thumb screws on the side of the
bracket that connects the indicator. The
Indicator can be placed on any flat
surface or mounted on the wall.
NOTE: The W, M and L versions have a rechargeable battery in the base unit.
The indicator must be connected to the base to charge the battery.
To re-charge the internal battery, connect the power supply module to the rear
of the indicator and apply power.
Before operating parts marked with a
operate with caution to avoid hazard.
© Adam Equipment Company 2014
2
Place the Stainless Steel pan on the base,
if it not already assembled.
For CPWplus L, place the optional rubber mat on
the pan for animal weighing.
4
Connect the cable attached to the base to the
connector at the rear of the indicator. Tighten
the ferrule to secure the cable.
Connector
on the
Indicator
Connector
attached to
the cable
Ferrule
NOTE: When moving the scale, take care to
prevent bending of the cable and connector too
much as over a period of time this can weaken
the wires in the connector and cause malfunction.
symbol please read this instruction manual and
7 9009RevD2-March 2017